BKK Fangs-62 UA Treble Hooks #6 (8pcs)

Product detailed description

BKK Fangs-62 UA #6 is a lightweight size that bridges light saltwater fishing and finer spinning. Based on SAF’s physical comparison, it is very well suited to pilkers and speed jigs up to 6 cm / around 20 g, spoons of a similar length, and smaller hardbaits, crankbaits, casting jigs or streamers measuring approximately 8–10 cm. Within SAF’s practical size map, this is the smallest Fangs-62 UA size that SAF still specifically recommends for rigging small saltwater metal lures. Its forged 2X wire still provides an above-average strength reserve for its size.

With a metal lure, weight alone does not determine the correct hook. A treble hook needs enough gape for its points to remain exposed beyond the sides of the lure body, but it must not repeatedly catch the lure during the fall or retrieve. A slim 20 g speed jig may work well with a smaller hook than a shorter but wider 20 g pilker. A length of up to 6 cm and weight of around 20 g are therefore practical starting points, not a fixed conversion. Body width and thickness, eye position, split-ring size and retrieve style must also be considered.

The 2X designation describes the wire and strength class, not an exact load rating in kilograms. Fangs-62 is neither a delicate 1X treble nor a heavy-duty hook for extreme fishing. Size #6 is lighter and less prominent than #5, so it preserves the action of a small lure more sensitively. Compared with #8, it provides more working gape and is better suited to metal lures around 20 g or wider bodies where the points of a smaller hook could remain too close to the sides.

The geometry is based on a traditional O’Shaughnessy bend. BKK combines it with a forged shank, regular eye and three needle-sharp points with standard barbs. According to the manufacturer, forging increases strength by approximately 20% compared with similar non-forged hooks. The reliability of the complete rig also depends on the sharpness of all three points, the condition of the split ring, leader strength, drag setting and the angle at which the fish takes the lure.

The hook is manufactured from BKK-81WV high-carbon steel and finished with an Ultra-Antirust (UA) coating for increased corrosion resistance in saltwater. Size #6 can therefore be used on small saltwater pilkers, speed jigs, spoons and streamers, as well as on freshwater lures for perch, asp, zander, pike, trout, chub and other predators. After saltwater use, rinse the hook with fresh water, allow it to dry completely and inspect both the points and the coating for mechanical damage.

On pilkers and speed jigs up to 6 cm and around 20 g, size #6 provides a very good starting balance between gape, profile and weight based on SAF’s physical comparison. On a slim jig, it helps preserve a clean fall and low resistance. On a wider pilker, confirm that the points do not remain hidden behind the sides of the body. After fitting the hook, check that it rotates freely, does not lie flat against the metal with all three points and does not repeatedly catch the lure during use.

On spoons up to approximately 6 cm long, low hook weight is particularly important. An excessively heavy treble can pull down the rear section, accelerate the fall and restrict the rocking or fluttering action. Size #6 adds less weight than #5 while still providing more working gape than #8. After replacing the original hook, compare not only the dimensions but also the spoon’s behaviour during a slow retrieve, pause and free fall.

On hardbaits, crankbaits and smaller topwater lures, size #6 is suitable mainly when its overall height, gape and weight match the original rigging. As an approximate guide, this may include lures measuring around 5–7 cm, but length alone is not enough. Lure construction, number of hooks, buoyancy and weight distribution can shift the correct size considerably. On a floating hardbait, monitor buoyancy; on a suspending model, check its neutral position; and on a topwater lure, confirm that it starts correctly and stays near the surface.

For streamers measuring approximately 8–10 cm, size #6 is a suitable starting point in both freshwater and saltwater, provided that the tying material leaves the points exposed. A slim or medium-density pattern may work very well with #6, while an exceptionally bulky streamer tied with fur or dense synthetic fibres may require #5. On a stinger rig, also consider the treble’s position within the lure profile, the lure’s buoyancy and whether the material folds over the points during the retrieve.

There is no rigid boundary between neighbouring sizes. #8 is the finer spinning choice for smaller hardbaits, crankbaits, spoons and other lightweight lures where low hook weight is the priority. #6 forms the working transition and, based on SAF’s recommendation, is well suited to pilkers and speed jigs up to 6 cm / around 20 g, similarly sized spoons and streamers measuring approximately 8–10 cm. #5 adds more working gape for metal lures measuring 6–6.5 cm / 20–30 g and streamers around 10 cm.

Within SAF’s practical size map, size #6 is the smallest size still given a clear role in light saltwater fishing. The smaller sizes #8, #10, #12, #14 and #16 are intended primarily for progressively finer spinning with small hardbaits, minnows, crankbaits, spoons, spinners and other compact lures. This does not mean that they cannot be used in saltwater; however, their primary role in SAF’s range is built around spinning lures rather than pilkers.

Fangs-62 UA #6 is not automatically a substitute for the more robust Raptor-Z, Raptor-X or Viper-41 ranges. These models make more sense when maximum resistance to straightening matters more than low hook weight and preservation of subtle lure action. Fangs-62 has a different role: it provides a lightweight, sharp, forged and corrosion-protected 2X treble hook with a favourable strength-to-weight ratio for both freshwater and saltwater.

The BKK Fangs-62 UA size table is an approximate guide to the complete range. It is not a universal conversion between lure length or weight and hook size. Before final rigging, always check the physical proportions of the specific lure, the original hook, split-ring size and freedom of movement.

This version contains 8 treble hooks in size #6. According to the reference chart, one hook weighs approximately 0.57 g. Before first use, check the sharpness of all three points and repeat the inspection after every contact with rock, a metal boat hull or another hard obstruction. Replace a blunt or mechanically damaged point; an intact-looking coating alone does not prove that the hook remains sharp.

BKK Fangs-62 UA #6 is suitable for anglers seeking a lightweight 2X treble hook at the transition between light saltwater applications and finer spinning. Its main applications include pilkers and speed jigs up to 6 cm / around 20 g, similarly sized spoons, smaller hardbaits and streamers measuring approximately 8–10 cm where #8 does not provide enough working clearance but #5 could unnecessarily alter the action of the lure.

Frequently asked questions – BKK Fangs-62 UA #6

Which lures suit size #6?

Size #6 is a suitable starting point for proportionally matched pilkers and speed jigs up to 6 cm / around 20 g, similarly sized spoons, smaller hardbaits, crankbaits, casting jigs and streamers measuring approximately 8–10 cm. Always confirm that the hook moves freely and that the lure body or tying material does not shield the points.

Is Fangs-62 UA #6 suitable for pilkers around 20 g?

Yes. Based on SAF’s physical comparison, #6 is a very good starting point for compact metal lures measuring up to 6 cm and weighing approximately 20 g. It is not a fixed conversion, however. Body width and thickness, eye position, split-ring size and retrieve style also matter.

Why is #6 the smallest size SAF still specifically recommends for light saltwater fishing?

Because its proportions still suit small pilkers and speed jigs around 20 g without adding unnecessary weight. The smaller UA-coated sizes #8 to #16 can also be used in saltwater, but SAF positions them primarily for progressively finer spinning with small hardbaits, crankbaits, spoons and spinners.

How should I choose a treble-hook size for a streamer measuring approximately 8–10 cm?

Do not consider length alone. A slim or medium-density streamer may work very well with #6, while a shorter but exceptionally bulky pattern may require #5. Consider the volume of the material, profile width, buoyancy, stinger position and whether the fibres shield the points.

What is the difference between sizes #8, #6 and #5?

#8 is the finer spinning choice for smaller, sensitively balanced lures. #6 forms the transition for pilkers and speed jigs up to 6 cm / around 20 g, similarly sized spoons and streamers measuring approximately 8–10 cm. #5 adds more working gape for metal lures measuring 6–6.5 cm / 20–30 g and streamers around 10 cm.

Can this treble hook be used in saltwater?

Yes. The Ultra-Antirust coating is designed to provide increased corrosion resistance in saltwater. After fishing, rinse the hook with fresh water, allow it to dry completely and inspect both the points and the coating before using it again.

Will size #6 change the action of the lure?

It can. According to the reference chart, one size #6 hook weighs approximately 0.57 g and may change the centre of gravity, buoyancy, water resistance or character of the fall compared with another hook. Compare the new rigging with the original setup and test the lure during a normal retrieve and free fall.

→ Full technical details are listed below in the Product Parameters table.

↓ Related and similar products are also shown below the description to help you choose the right components and build a complete setup.