Savage Gear Regenerator Mono 0.60 mm / 20 kg, 30 m

Product detailed description

Regenerator 0.60 mm is a practical leader for heavier sea lure fishing and vertical work with soft baits or metal lures. It retains the range’s soft character with more cross-section than 0.50 mm. Beyond a direct leader, it can serve in a lighter homemade sea rig when the body and branches suit the baits and hook count.

Soft copolymer monofilament is Regenerator’s defining character. A supple leader gives the bait room to move, with stretch helping cushion sudden terminal loads. It is not fluorocarbon, and another leader material’s behaviour cannot be transferred on diameter alone. The 30 m pack supplies individual leaders; it is not intended as a complete deep-sea reel main line.

Neighbouring diameters and rig choice. Move up from 0.50 mm for a larger cross-section in heavier lure fishing. Consider 0.70 mm for larger lures or a more demanding rig body. Neither step alone determines jig-head weight or a permissible drag setting.

A direct leader has two different connections: leader to braid and leader to lure. The upper joining knot must seat correctly in both materials and, where necessary, pass through the rod guides. The lower snap should allow lure changes without being oversized. Watch for twist with a rotating metal lure or bait and use an appropriate swivel where needed. Check the lure in water where you can see its action.

For a tied connection, choose a knot suited to the actual monofilament and eye. Moisten it, align the turns and tighten steadily. If the line whitens, turns cross or the knot bears against a sharp edge, cut it off and retie. A crimped loop is an additional option only with a suitable sleeve and tool; their size cannot be copied from another diameter on similar breaking strain alone. Test each new connection under controlled tension.

Do not convert the 20 kg label figure into a fish weight you can lift by the trace. Connections, hardware and wear affect the completed rig. Inspect the terminal section and areas beside eyes after bottom or fish contact. Cut away damaged line, rinse used sea rigs in fresh water and let them dry. Keep spare material away from heat and direct sunlight. Abrasion resistance is not guaranteed bite protection; choose an appropriate terminal material when sharp teeth require it.

Frequently asked questions (FAQ)

When should I choose Savage Gear Regenerator Mono 0.60 mm?

Heavier lure fishing and lighter homemade sea rigs.

Can it be the body of a cod tube-eel rig?

Its primary role is a terminal lure leader. Choose a substantial multi-hook rig body separately for bait count, branch length and the cross-section required.

Should I tie or crimp this diameter?

A tied connection is a practical option when the selected knot seats neatly in the actual eye. Moisten, align and test it. Crimping requires its own matched sleeve and procedure.

What should I check at the lure before fishing?

Check lure movement in the water, snap size, eye smoothness and the leader beside the lower connection. On a rig, also check branch length and spacing.

Does 20 kg describe the strength of the complete rig?

No. It is a declared material figure; connections, components and wear affect the finished rig. It is not a fish weight that can be lifted by the line.

When should I rebuild the trace?

After cuts, rough spots, flattening or damage beside an eye or connection. Remove the damaged section and test the replacement end fitting.

→ All detailed technical information is available below in the Product parameters table.

↓ Below the product description, you will also find related and similar products to help you choose and put together a complete setup.