VMC 9147 BN #4 Jig Hook

Product detailed description

The VMC 9147 BN #4 Jig Hook suits small paddle tails and soft jerkbaits that need a slightly larger hook while retaining a finesse setup. With a fuller body, check that the lure does not fill the space inside the hook bend; with a slim body, check where the point sits relative to the active rear section. It is a step up from #6, but do not confuse #4 with 4/0, which is a much larger size. Confirm your choice against the actual lure you will fish.

When rigged, the soft lure must sit straight on the shank and leave the hook bend and point enough room to work. On a slim soft jerkbait, keep the rear section free to move; on a deeper-bodied paddle tail, also check the space inside the hook bend. Before casting a batch, always test the actual hook in a dry mould and make sure the mould closes fully.

Choosing a mould and using size #4

For the VMC 9147 BN #4, choose a mould that explicitly lists this model and size. A similar cavity shape or matching hook angle does not establish compatibility on its own. During a trial fitting, the hook should sit in place without forced bending and the mould must close fully.

The pack contains 20 or 100 VMC 9147 BN hooks in size #4, depending on the selected variant. The smaller pack suits testing a particular setup; the larger pack suits repeated production of jig heads with the same hook.

For casting your own jig heads, you can add an RCBS Easy-Melt 240V melting pot or a Lyman Big Dipper 230V. Finish the cast heads with the Amigo fluid bed and powder paints for lead.

Technical note: The VMC 9147 has a Regular shank and a Flat Eye Jig eye with a 90° front bend. Eagle Claw 570B, VMC 5150 and VMC 7161 in the similar products section are included for comparing designs. They are not automatically interchangeable; the VMC 7161 also has 60° geometry. Check the mould specification again whenever you change hook model.

Frequently asked questions about VMC 9147 BN #4

Is #4 the same size as 4/0?

No. 4/0 is a much larger size.

What does Aberdeen Jig 90° mean?

It is a classic Aberdeen jig hook with a 90° front bend. The design is intended for making conventional jig heads.

What does BN mean?

BN stands for the Black Nickel finish. It does not describe the hook shape or a strength rating.

Can I replace a VMC 9147 with a VMC 5150 of the same size?

Not automatically. Both models have a 90° front bend, but the hook bend, shank and eye differ. Always check compatibility with the particular mould.

How can I tell whether a soft lure is rigged correctly?

The lure should sit straight behind the head, the point should exit through a solid section of the body, and the active rear section must remain free.

→ All detailed technical information is available below in the Product parameters table.

↓ Below the product description, you will also find related and similar products to help you choose and put together a complete setup.