Gamakatsu Jig 90 2/0 Jig Hook

Product detailed description

Gamakatsu Jig 90 2/0 suits larger perch lures and typical smaller soft lures for zander. Compared with 1/0, it lets you position the point farther along the solid section of the lure without automatically changing the head weight. A correctly rigged lure sits straight and leaves enough space inside the hook bend.

The soft lure should sit straight behind the jig head. The point should exit through a solid section of the body, leaving enough space between the lure and the hook bend for a secure hookset. With a slim soft jerkbait, focus on where the point exits. With a deeper-bodied paddle tail, also check that the lure body does not fill too much of the hook bend.

Before casting a batch, always test the particular hook size in a dry mould. The hook must sit correctly in its groove, and the mould must close freely and fully. If the hook does not fit, do not bend it to suit the mould. Use the correct hook instead.

The same 90° front bend does not make this hook automatically interchangeable with the VMC 5150 RD or VMC 5150 BN. These are different model ranges, and compatibility must be checked for the particular mould.

To choose a mould, browse our jig head moulds. This category link does not confirm that any particular mould is compatible with this hook.

The original retail pack contains 25 Gamakatsu Jig 90 hooks in size 2/0.

Frequently asked questions

Do I need to move up to 3/0 when using a heavier jig head?
No. Choose the hook size to suit the soft lure and mould compatibility. Head weight mainly affects the sink rate and how the lure is presented.

Is the Gamakatsu Jig 90 suitable for salt water?
Yes. The manufacturer explicitly recommends the Jig 90 range for fresh and salt water. After use at sea, rinse the rig with fresh water and let it dry.

What does NS Black mean?
NS Black is the name Gamakatsu uses for the dark finish on this European product range. At SAF, we retain the manufacturer's original designation.

Is the Gamakatsu Jig 90 the same as the VMC 5150?
No. Both ranges have a 90° front bend, but they are different models. The same hook size does not automatically guarantee compatibility with the same mould.

How do I choose the right hook size?
Choose the hook according to the length and depth of the soft lure and where the point should exit. Jig head weight alone does not determine hook size.

→ All detailed technical information is available below in the Product parameters table.

↓ Below the product description, you will also find related and similar products to help you choose and put together a complete setup.