Savage Gear Regenerator Mono 0.90 mm / 41 kg, 30 m

Product detailed description

Regenerator 0.90 mm suits larger sea lures and substantial natural-bait traces, including setups for ling and halibut. The emphasis is on the terminal section between braid and rig. The soft construction still allows bait movement, but this diameter is not interchangeable with a finer leader chosen for a delicate lure presentation.

Soft copolymer monofilament is Regenerator’s defining character. A supple leader gives the bait room to move, with stretch helping cushion sudden terminal loads. It is not fluorocarbon, and another leader material’s behaviour cannot be transferred on diameter alone. The 30 m pack supplies individual leaders; it is not intended as a complete deep-sea reel main line.

Neighbouring diameters and rig choice. 0.90 mm adds cross-section over the preceding version. Move to 1.05 mm for an even more substantial end section ahead of bulky bait; do not attach a smaller lure through oversized hardware simply to gain a larger label figure.

On a natural-bait trace, the fish bait should move without repeatedly twisting the body. Plan hook position, trace length and sinker placement together. With bulky bait, check its behaviour as the boat moves too. When used ahead of a jig, treat the lure’s hook arrangement as a separate design: a terminal leader between braid and jig is not automatically the stinger running along the soft body.

Choose the end connection for the actual eye and the material’s behaviour in it. A knot must seat cleanly without forced bending or surface damage. For a more compact end loop, or where thick material deforms poorly in a knot, use a tested crimped design. Match sleeve, tool and procedure to the actual diameter; a similar sleeve label does not guarantee a suitable bore. Test each new connection under controlled tension.

Do not convert the 41 kg label figure into a fish weight you can lift by the trace. Connections, hardware and wear affect the completed rig. Inspect the terminal section and areas beside eyes after bottom or fish contact. Cut away damaged line, rinse used sea rigs in fresh water and let them dry. Keep spare material away from heat and direct sunlight. Abrasion resistance is not guaranteed bite protection; choose an appropriate terminal material when sharp teeth require it.

Frequently asked questions (FAQ)

When should I choose Savage Gear Regenerator Mono 0.90 mm?

Substantial leaders and natural-bait traces.

Can it be the body of a cod tube-eel rig?

Its main emphasis is a substantial natural-bait trace or terminal leader. For a conventional tied tube-eel system, also compare more appropriate finer versions in the range.

Should I tie or crimp this diameter?

Use a tied connection where the knot seats cleanly without damage. Consider a correctly matched crimped loop for a compact heavy-duty end fitting.

Is the leader also a stinger?

No. The leader connects the main line to the lure; the stinger carries hooks along the soft body and needs its own suitable fittings.

Does 41 kg describe the strength of the complete rig?

No. It is a declared material figure; connections, components and wear affect the finished rig. It is not a fish weight that can be lifted by the line.

When should I rebuild the trace?

After cuts, rough spots, flattening or damage beside an eye or connection. Remove the damaged section and test the replacement end fitting.

→ All detailed technical information is available below in the Product parameters table.

↓ Below the product description, you will also find related and similar products to help you choose and put together a complete setup.