Savage Gear Regenerator Mono 1.05 mm / 52 kg, 30 m

Product detailed description

Regenerator 1.05 mm is a choice for substantial natural-bait traces and short terminal sections ahead of large halibut jigs. The priority is a robust leader for bulky bait and demanding handling beside the boat, rather than a general cod rig. Its soft character still distinguishes it from stiff Platil, but the end connections deserve as much attention as the line itself.

Soft copolymer monofilament is Regenerator’s defining character. A supple leader gives the bait room to move, with stretch helping cushion sudden terminal loads. It is not fluorocarbon, and another leader material’s behaviour cannot be transferred on diameter alone. The 30 m pack supplies individual leaders; it is not intended as a complete deep-sea reel main line.

Neighbouring diameters and rig choice. Compared with 0.90 mm, both cross-section and connection bulk increase. For smaller lures or less demanding natural-bait setups, consider the appropriate finer version rather than choosing this size automatically for every Norway trip.

Ahead of a large jig, separate the leader’s role from the stinger. The leader connects the main line to the lure; the stinger carries hooks along the soft body and needs its own suitable fittings. On a natural-bait system, check that bait, hook and sinker do not readily tangle while lowering or retrieving. A heavy setup must remain manageable beside the boat, so choose length and hardware for a clear purpose.

For this heavy-duty class we recommend crimped end connections. The sleeve bore must suit the actual diameter and material path through the loop; use the appropriate tool and procedure for that sleeve. An excessive crimp may damage the line, while an insufficient one may fail to hold it. Follow the component manufacturer’s guidance and test each new connection before fishing. A bulky conventional knot forced into a small eye is not the recommended solution here.

Do not convert the 52 kg label figure into a fish weight you can lift by the trace. Connections, hardware and wear affect the completed rig. Inspect the terminal section and areas beside eyes after bottom or fish contact. Cut away damaged line, rinse used sea rigs in fresh water and let them dry. Keep spare material away from heat and direct sunlight. Abrasion resistance is not guaranteed bite protection; choose an appropriate terminal material when sharp teeth require it.

Frequently asked questions (FAQ)

When should I choose Savage Gear Regenerator Mono 1.05 mm?

A robust leader ahead of large jigs and natural-bait rigs.

Can it be the body of a cod tube-eel rig?

This is not recommended for an ordinary tube-eel system. Choose it for the heaviest natural-bait traces and short leaders ahead of large halibut jigs.

Should I tie or crimp this diameter?

For the heavy-duty use described here, we recommend crimped end connections with a suitable sleeve and tool. Bulky conventional knots forced into small eyes are not recommended.

Is the leader also a stinger?

No. The leader connects the main line to the lure; the stinger carries hooks along the soft body and needs its own suitable fittings.

Does 52 kg describe the strength of the complete rig?

No. It is a declared material figure; connections, components and wear affect the finished rig. It is not a fish weight that can be lifted by the line.

When should I rebuild the trace?

After cuts, rough spots, flattening or damage beside an eye or connection. Remove the damaged section and test the replacement end fitting.

→ All detailed technical information is available below in the Product parameters table.

↓ Below the product description, you will also find related and similar products to help you choose and put together a complete setup.